EarthQuake CRT series Manual do Operador descarregar pdf (Página 6)

Operator’s Manual

6015 Series CRT Rototiller

6 Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

FIGURE 1

handlebar extensions

handlebar

lower handlebar mount

CAUTION

DO NOT TRY TO LIFT THE ROTOTILLER FROM THE

CARTON.

DO NOT ADD ENGINE OIL INTO GEAR CASE DIPSTICK

HOLE.

UNPACKING AND ASSEMBLY

Your rototiller comes fully assembled except for a few parts.

The following instructions will help you unpack your tiller and

assemble and adjust your tiller’s depth regulator lever, cable

tension and handlebar height. You will need 2- 9/16” wrenches.

UNPACK

1. Open top of carton and remove handlebar assembly.

2. Find parts packet. Parts packet contains:

2 - 3/8-16 x 1” hex head bolts*

4 - 3/8-16 x 1-3/4” hex head bolts

6 - 1/4-20 x 3/4” hex head bolts

6 - 1/4-20 nylock nuts

6 - 3/8-16 nylock nuts**

1- detent pin

 

 

 

 

NOTE: Parts packet also includes Engine Manual, Warranty

Card and this Operator’s Manual.

3. Cut open seems of carton, exposing all contents and remove

machine by:

a. Attaching loose wheels in box onto machine with lock pin

in free-wheel position. (SEE PAGE 12)

b. Roll tiller from carton.

* CE (European Version) includes (4) 3/8-16 x 1 hex head bolts

** CE includes (8) 3/8”-16 nylock nuts and (8) 3/8” at washers

*** Only CE model incudes second set of handlebar extensions

ATTACH HANDLEBAR 6015V AND 6015B, U.S.

1. Locate handlebar extensions. (SEE FIGURE 1)

2. Place handlebar extensions on outside of lower handlebar

mount. Line up the handlebar extension pieces with the

lower handlebar mount as shown in the decal located on

the lower handlebar mount next to the mounting location.

(SEE PAGE 20)

3. Insert one 3/8-16 x 1 3/4” bolt for each side in lower holes of the

extension pieces. The bolts will pass through the lower hole of





5. Now assemble the handlebar to the handlebar extensions.

   

extensions.

6. Insert one 3/8-16 x 1-3/4” bolt for each side in lower holes of the



of the lower handlebar mount along with the middle holes of



IMPORTANT

THE RIGHT AND LEFT SIDES OF YOUR

ROTOTILLER ARE DETERMINED FROM

THE OPERATING POSITION AS YOU FACE

THE DIRECTION OF FORWARD TRAVEL.

ENGINE IS SHIPPED FROM FACTORY

WITHOUT OIL. YOU MUST ADD ENGINE

OIL BEFORE STARTING ENGINE.

TILLER TRANSMISSION IS SHIPPED FROM

FACTORY WITH THE PROPER AMOUNT

OF GEAR LUBE.



8. Insert one 3/8-16 x 1 bolt for each side in upper holes of

   





10. Tighten 3/8-16 nuts on each of the 6 bolts connecting the

handlebar, handlebar extensions and handlebar mount

together.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentários a estes Manuais

Sem comentários

EarthQuake CRT series Manual do Operador Página 6

Comentários a estes Manuais