EarthQuake CRT series Manual do Operador descarregar pdf (Página 12)

Operator’s Manual

Front Tine Tiller 3365 Series

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST

BELT REPLACEMENT PART #:

3370 (forward)

CHECK BELT TENSION

Belt tension may decrease over time. It must be adjusted within the

rst half hour of operation and checked after every two hours of

operation. Proper adjustment will assure long belt life. Too much or too

little belt tension will cause premature belt failure. To check and adjust

the forward belt tension:

1. Turn o engine. Engine must be cool.

2. Remove spark plug wire from spark plug and secure.

3. With drive safety control lever in the NEUTRAL position, measure

length of spring when in its relaxed state.

4. Pull down on drive safety control lever and measure length of

spring when compressed. Ideal length would be 1/4” shorter.

CHANGE FORWARD BELT

1. Turn o engine. Engine must be cool.

2. Remove spark plug wire from spark plug and secure.

3. Remove front belt cover.

 • Removethebeltfromtheenginepulley:

  - Gentlypulltheenginerecoilropetorotatethepulley.

- With the pulley turning, force the belt out of the V-groove.

- Slide the belt free of the engine pulley.

- Pull the belt down and out of the way.

- Push the belt forward and out front of machine.

 • Installnewbelt:

- Place belt in transmission pulley groove.

  - Gentlypulltheenginerecoilropetorotatethepulleywhile

forcing the belt into the V-groove.

4. Replace front belt cover.

5. Attach spark plug wire.

CHECK FORWARD BELT TENSION REGULARLY. TOO MUCH

OR TOO LITTLE TENSION WILL CAUSE PREMATURE BELT

FAILURE.

WARNING

remove belt

from front

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sem comentários

EarthQuake CRT series Manual do Operador Página 12